S M HUDSON

Boatbuilders

Steelwork - Key Features

The distinctive shape, style and attention to detail applied to our steelwork is what gives the first positive impression of a S M Hudson boat.

Whether you choose:

  • our minimum length of 50 feet
  • our maximum of 72 feet
  • modern engine or engine room

... the quality and distinctive shape are the same.

Standard specification

Hull

  • Josher style bow and stern
  • Swims of over 14 feet to bow and stern
  • Built from prime 43A grade steel
  • 10mm base - 6mm hull - 5/4 cabin

Framing

  • Full length 150mm x 75mm channel keelson – centre of base plate
  • Floor bearers 75mm 50mm x 6mm
  • Knees 50mm x 50mm x 6mm – vertical on hull sides
  • Full length Hull stringers 75mm x 50mm x 6mm – horizontal on hull sides
  • Cabin framing 50mm x 25mm x 6mm channel
  • Main cabin roof beams 25mm x 25mm box – latticed with 25mm x 25mm box

General Specification

  • Solid skeg 150mm x 25mm
  • Solid rudder post 50mm diameter
  • 4 full length guards 50mm wide welded top and bottom – 1 above and 1 below waterline each side
  • Solid stem post 70mm x 40mm
  • Diesel tank with inspection hatch (traditional boats only)
  • Vented gas locker
  • Weed hatch with easy access through lifting hatch on back deck
  • Engine beds to suit specified engine
  • Keel cooling tank
  • Self-draining front and rear decks
  • T stud and dollies
  • Fully welded bow flares
  • Permanent security numbers
  • Window and vent apertures cut in cabin